What are the responsibilities and job description for the Dimensional Inspector position at HOLTEC INTERNATIONAL?
Essential Job Functions/Responsibilities
Adherence to safety procedures/guidelines at all times; maintain safety precautions at all times.
Keep work area in a clean and orderly condition.
Perform receipt and in-process inspections on material purchased by Holtec or supplied by Holtec’s customers for use in fabrication; document and/or record inspection results; report results as required.
Familiar with the basic inspection tools and equipment (calipers, scales, micrometer, “go-no-go” gauges, thread gauges, tape measure, etc.) and have demonstrated proficiency in their use.
Capable of determining the calibration status of inspection and measuring equipment is in proper condition for use, and that inspection, examination and test procedures are approved.
Capable of assisting production in the set-up of material and/or components for receipt inspection as required.
Reviewing of Certified Material test Reports and verifying conformance to purchase order requirements.
Record time on proper forms.
Perform audits/surveillances as required by management.
Other duties as assigned
Physical Demands & Abilities
May be required to work at heights and/or in confined spaces.
May work alone with minimal supervision or with other personnel.
Will work in various areas of the plant location. Dependent upon the area, environmental conditions may be hot, cold, dirty, greasy, wet and/or noisy.
Ability to walk, climb, crawl, bend, crouch, and use ladders.
Required and Preferred Qualifications
High school diploma or equivalent required
Minimum of 1 year prior experience performing dimensional inspections and using measuring tools (calipers, scales, micrometer, “go-no-go” gauges, thread gauges, tape measure, etc.) required.
Understanding of GDT (Geometrical Dimensioning and Tolerancing) required.
